Installation guide

BlackDiamond 8800 Series Switches Hardware Installation Guide
55
LEDs
The front panel of the Extreme Networks 700/1200 W AC PSU provides status LEDs. Table 14 describes
the LED activity.
Power Supply Cords
The Extreme Networks 700/1200 W AC PSU(s) can be used with either a 110 V AC or a 220 V AC
power supply cord. If you use a 110 V AC power supply cord, the maximum DC output power of
the PSU is 700 W. If you use a 220V AC power supply cord the maximum DC output power of the PSU
is 1200 W.
An AC power supply cord is not shipped with the 700/1200 W AC PSU. To purchase an AC power
cord, contact your local Extreme Networks Channel Account Manager or Sales Manager, or purchase a
cord from your local supplier. All power supply cords must meet the requirements listed in “Selecting
Power Supply Cords” on page 172.
Fuse
The Extreme Networks 700/1200 W AC PSU line and neutral legs are both fused. Power to the switch
may still be live if the neutral fuse is open. This is not a field operator replaceable fuse. In the event of
failure, immediately return the Extreme Networks 700/1200 W AC PSU for a complete replacement.
WARNING!
Field operators must not attempt to configure or replace fuses in Extreme Networks 700/1200 W AC PSUs! In the
event of failure, immediately return the defective Extreme Networks 700/1200 W AC PSU for a complete
replacement.
Table 14: LEDs on the 700/1200 W AC PSU
PSU Condition
Power
Green
Predictive Fail
Amber
Fail
Amber
Power supply AC outputs working normally On Off Off
AC input power present/standby output on Blinking Off Off
Current limit on 48 VDC output On Off Blinking
Predictive failure On Blinking Off
No input power to this PSU only Off Off On
No input power to any PSU Off Off Off
Power supply failure Off Off On