Installation guide
BlackDiamond 8000 Series Modules
BlackDiamond 8800 Series Switches Hardware Installation Guide
46
8900-G96T-c
The 8900-G96T-c I/O module (Figure 28) has 96 10/100/1000BASE-T ports using MRJ21 connectors.
Each connector provides six ports.
NOTE
The 8900-G96Tc module is not compatible with the 10G4X module. If an 8900-G96Tc module and a 10G4X
module are installed in the same chassis, only one of these modules will function.
Figure 28: 8900-G96T-c I/O Module
In the default configuration of the 8900-G96T-c I/O module, all ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
● Operate in autonegotiation mode
A pushbutton switch at the right of the module front panel selects which of two port groups are
displayed by the port LEDs.
The 8900-G96T-c I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the 8900-G96T-c I/O module, see “I/O Module
LEDs” on page 50.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
13
14
15 16
17
18
19
20
21 22
23
24
25 26
27
28
29
30 31 32 33 34 35 36 37 38
39
40
41 42
43
44
45
4846
47
49
50 51 52 53
54
55
56
57
58
59
60 61 62 63 64 65 66 67 68
69
70
71 72
73
74
75
76
77
78
79
80 81 82 83 85
85
84 86
86
87
87
88
88
89
89
90
90
91
91
92
92
93
93
94
94
95
95
96
96
1~48
49~96
Push
Button
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
48
46
47
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
96-port 10/100/1000BASE-T, MRJ21
41532