Installation guide

BlackDiamond PSU Covers
BlackDiamond 8800 Series Switches Hardware Installation Guide
144
5 Push the top of the cover into place against the front of the switch until the latching tabs click into
place (Figure 103).
Figure 103: Latching the PSU Cover
Removing the BlackDiamond 8810 PSU Cover
To remove the PSU cover:
1 Press down on the latching tab at each side of the top.
2 With the latching tabs pressed down, pull outward on the top edge of the cover to disengage it from
the switch chassis.
3 Lift the cover off the AC cord retainer.
EX_192