Installation guide

BlackDiamond PSU Covers
BlackDiamond 8800 Series Switches Hardware Installation Guide
142
BlackDiamond 8810 PSU Cover
The BlackDiamond PSU cover fits onto the AC power cord management bracket and snaps into place
on the front of the BlackDiamond 8810 switch. The PSU cover kit includes the following parts
(Figure 100):
● PSU cover
● AC power cord management bracket with captive retaining screws
Figure 100: PSU Cover Kit
Installing the BlackDiamond 8810 PSU Cover
To install the PSU cover:
1 If necessary, remove the installed AC cord retainer.
2 Make sure that all required AC power cords are connected to the AC input connectors on the switch.
3 Attach the AC power cord retainer to the switch:
a Place the retainer against the front of the switch as shown in Figure 101. Make sure that the
retainer engages all the power cord connectors.
b Align and tighten the captive retaining screws.
EX_189