Installation guide

Installing Power Supply Units in the BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
106
Be sure that the DC PSU is fully seated in the switch.
CAUTION
Do not slam the 1200 W DC PSU into the chassis backplane.
Figure 64: Installing the 1200 W DC PSU in the Power Supply Bay
4 Verify that the DC power is turned off at the source.
CAUTION
Always verify that the DC circuit is de-energized before you connect the input cable to the 1200 W DC PSU.
5 Connect the input DC cable to the front of the 1200 W DC PSU as shown in Figure 65.
NOTE
An AC power cord is not required for proper functioning of the DC PSU.
6 Rotate the locking handle down to latch the input cable connector onto the DC PSU.
EX_131