Install guide

Using the Graphical User Interface (GUI) on AT-9900 Switches show gui 1-21
Software Release 2.7.4
C613-10444-00 REV A
show gui
Syntax SHow GUI
Description This command displays information about the GUI status and the GUI
resource file. The resource file contains the HTML pages that make up the GUI
(Figure 1-9, Table 1-2 on page 1-21).
Figure 1-9: Example output from the show gui command
GUI Configuration
-------------------
Module Status : Enabled
Resource File
-----------------------
Name : s_sb8e01.rsc
Status : Good
Header Info
-----------------------
Type : Switch
Model : Switchblade 4000
Gui Builder Version : 2.1
Language : English
Version : 01
File Creation Date : 5/4/2002
Build Type : PRODUCTION
File Size : 1260309
Table 1-2: Parameters in the output of the show gui command
Parameter Meaning
Module Status Whether the GUI is enabled or disabled.
Name Filename of the GUI resource file.
Status State of the resource file; either Good (no errors in the file)
or Error. If the state is Error, a line is displayed below the
status indicating the nature of the error.
Type Type of GUI.
Model The model the resource file has been produced to run on.
Resource files are model-dependent, so this must be the
same model as the switch.
GUI Builder Version Version of the Allied Telesyn GUI creation program that this
resource file was built with.
Language Language in which the GUI is displayed.
Version Version of the GUI.
File Creation Date Date in day/month/year format when the resource file was
created.
Build Type The status of this build. “Production” indicates a build that
has been released for use.
File size Byte size of the resource file.