Install guide

1-18 Command Reference Release Note
Software Release 2.7.4
C613-10444-00 REV A
address range. See “HTTP Proxy Servers” on page 1-4 for more
information.
■ If you cannot access the GUI because your username or password fails,
check that you are spelling them correctly. The username “manager” will
always be valid. Its default password is “friend”. Note that passwords are
case sensitive.
Problem The GUI is behaving inconsistently, or you cannot access some pages.
Solution
■ Delete your browser’s temporary files (see “Deleting Temporary Files” on
page 1-17) and try again.
■ Check that JavaScript is enabled.
■ If you are using a toolbar or plug-in on your browser to block pop-ups,
disable it while using the GUI. The GUI displays detailed configuration
options and information in pop-up windows.
Either turn the toolbar off or specify that pop-ups are allowed for the IP
address of the router. To turn off a toolbar on Internet Explorer 6, select
Toolbars from the View menu and make sure the toolbar is not checked.
■ Check that you are trying to access the GUI from a supported operating
system and browser combination. See “Browser and PC Setup” on page 1-3
for more information.
Problem The GUI does not seem to configure the switch correctly.
Solution
■ Use the buttons on the GUI pages to navigate, not your browser’s Back,
Forward or Refresh buttons. The GUI’s navigation buttons perform aspects
of the configuration.
■ If you are using a toolbar or plug-in on your browser to block pop-ups,
disable it while using the GUI. The GUI displays detailed configuration
options and information in pop-up windows.
Either turn the toolbar off or specify that pop-ups are allowed for the IP
address of the router. To turn off a toolbar on Internet Explorer 6, select
Toolbars from the View menu and make sure the toolbar is not checked.
Command Reference
This section describes the commands available on the switch to support day-to-
day operational and management activities.
The shortest valid command is denoted by capital letters in the Syntax section.
In your Software Reference, see
■ “Conventions” in About this Software Reference for details of the
conventions used to describe command syntax
■ Appendix A, Messages for a complete list of messages and their meanings.