Install guide

Using the Graphical User Interface (GUI) on AT-9900 Switches 1-9
Software Release 2.7.4
C613-10444-00 REV A
7. If you want to be able to browse to the GUI securely, configure SSL (Secure
Sockets Layer).
For a step-by-step example, see “Configuration Example” in the Secure
Sockets Layer (SSL) chapter of your Software Reference.
8. Save the configuration and set the switch to use it on bootup.
create config=filename.cfg
set config=filename.cfg
9. On the PC, bypass the HTTP proxy server, if necessary.
See “HTTP Proxy Servers” on page 1-4 for more information.
10. Point your web browser at the LAN interface’s IP address.
For normal access, point your web browser to
http://ip-address
For secure access, point your web browser to
https://ip-address
where ip-address is the interface’s IP address.
For more information about secure access, see “Configuration Example” in
the Secure Sockets Layer (SSL) chapter of your Software Reference.
11. At the login prompt, enter the user name and password.
The default username is manager:
User Name: manager
Password: friend
The System Status page is displayed (Figure 1-5 on page 1-11). Select
options from the sidebar menu to configure and manage the switch.
Option 3: Connecting to an Installed Switch
Use this procedure if at least one interface on the switch already has an IP
address, and the switch is already installed in a LAN.
1. Find out the IP address of the switch’s interface.
Ask your system administrator. Alternatively, access the CLI, as described
in your Installation and Safety Guide or Quick Install Guide, and enter the
command:
show ip interface
Important You can browse to the switch through any VLAN, as long as you
give that VLAN an IP address (below). These instructions assume you use
vlan1. The switch ports all belong to vlan1 by default.
2. Select a PC.
You can browse to the GUI from any PC that:
• has an IP address in the same subnet as the switch, or that the switch
has a route to
• is running a supported operating system
• has a supported browser installed, with JavaScript enabled
See “Browser and PC Setup” on page 1-3 for more information.