Install guide

Software Version 2.7.4 41

Software Version 2.7.4

C613-10444-00 REV A

Syntax for set clauses SET IP ROUTEMap=routemap ENTry=1..4294967295

[ACtion={INCLude|EXCLude}] SET METRIC=0..4294967295

SET IP ROUTEMap=routemap ENTry=1..4294967295

[ACtion={INCLude|EXCLude}] SET TYPE={1|2}

SET IP ROUTEMap=routemap ENTry=1..4294967295

[ACtion={INCLude|EXCLude}] SET TAG=1..65535

The routesource and prefixlist parameters use a pre-configured prefix list.

Prefix lists are already used by BGP and are described in the Border Gateway

Protocol version 4 (BGP-4) chapter of your router or switch’s Software

Reference.

set ospf

Syntax SET OSPF [INROUTEMAP=[routemap-name]] [other-options...]

The inroutemap parameter specifies a route map to filter OSPF routes before

adding them to the IP route table for IP to use. This route map can match on

any of the route map options that are valid for OSPF: interface, prefix list, next

hop, route source, metric, route type or tag.

show ip routemap

Syntax SHow IP ROUTEMap=[routemap]

This command displays entries for the new route map match and set options.

Figure 21: Example output from the show ip routemap command

IP route Maps

Map Name

Entry Action

Clauses

------------------------------------------------------------

1 Include

match Interface vlan1

set Tag 1

------------------------------------------------------------