Install guide

Software Version 2.7.4 27
Software Version 2.7.4
C613-10444-00 REV A
Displaying and Disabling All Active
Debugging
This enhancement provides an easy way to:
■ see which protocols currently have debugging enabled
■ disable debugging for all these protocols at once.
New and Modified Commands
show debug active
Syntax SHow DEBug [ACTive={ALL|module}]
where module is the name of a switch or router module from the following list:
BGP, INTERFACE, IP, LACP, MSTP, OSPF, PIM, RADIUS, STP, SWITCH,
TACACS, TACPLUS or VRRP.
The output only shows the modules from this list that have debugging
enabled. It does not list modules:
■ for which debugging is disabled
■ which are not in the list, even if debugging is enabled for them
Figure 16: Example output from the show debug active command
Active Debug
BGP:
Debug Types Peer IP Address
-------------------------------------
msg -
state 192.168.1.20
-------------------------------------
DHCP: (no options available)
IP IGMP:
Destination IP Address Source IP Address
-------------------------------------------
224.1.2.3 -
- 10.10.10.1
- 192.168.1.20
- 192.168.2.20
-------------------------------------------
LOAD BALANCER:
Debug Types Enabled:
http
firewall
trace