Install guide

24 Summer Time Release Note
Software Version 2.7.4
C613-10444-00 REV A
Summer Time
This enhancement enables you to:
■ define a timezone
■ enable summer time (daylight saving time) and specify when summer time
starts and ends.
Once summer time is enabled, the local time automatically changes when
summer time begins and ends.
You still need to set the local time by using the command:
set time
If you set the time before configuring summer time, set the time to standard
time even if summer time currently applies. When you configure summer time
the router or switch will automatically change the time to show summer time if
necessary.
If you set the time after configuring summer time, set the time to the current
local time: either summer time or standard time, whichever currently applies.
New Commands: Timezone
clear timezone
Syntax CLear TIMEZone
This command removes the timezone definition from the system, which is
equivalent to setting a timezone of UTC±00:00.
set timezone
Syntax SET TIMEZone[=timezone-name] [UTCoffset=std-utc-offset]
where:
■ timezone-name is a character string from 1 to 7 characters in length
representing the timezone abbreviation for standard time for this timezone
■ std-utc-offset is the amount of time by which this timezone is offset from
UTC time during standard time (not summer time). Time is a positive or
negative number in the format hh[:mm[:ss]], where hh=0-23, mm=0-59 and
ss=0-59. If hours are specified then minutes and seconds are optional. If
minutes are specified then seconds are optional.
This command supersedes the command set utc offset.