Install guide

2 Introduction Release Note
Software Version 2.7.4
C613-10444-00 REV A
Introduction
Allied Telesyn announces the release of Software Version 2.7.4 on the products
shown in Ta ble 1. This Release Note describes the new features in Software
Version 2.7.4 on any product. The product series each feature and enhancement
applies to are shown in “Overview of New Features” on page 4.
This Release Note should be read in conjunction with the Installation and
Safety Guide or Quick Install Guide, Hardware Reference, and Software
Reference for your switch or router. These documents can be found on the
Documentation and Tools CD-ROM packaged with your switch or router, or at
www.alliedtelesyn.com
www.alliedtelesyn.co.nz/documentation/documentation.html
This Release Note has the following sections:
1. Upgrading to Software Version 2.7.4
This section lists the file names that may be downloaded from the web site.
2. Description of New Features in Software Version 2.7.4
This section lists the features that are new for Software Version 2.7.4 and
describes how to configure them.
3. Using the Graphical User Interface (GUI) on AT-9900 Switches
Caution: Information in this document is subject to change without notice and
does not represent a commitment on the part of Allied Telesyn Inc. While every
effort has been made to ensure that the information contained within this
document and the features and changes described are accurate, Allied Telesyn
Inc. can not accept any type of liability for errors in, or omissions arising from,
the use of this information.
Table 1: Products supported by Software Version 2.7.4
Product series Models
AT-9900 AT-9924T, AT-9924SP, AT-9924T/4SP
AT-8900 AT-8948
SwitchBlade AT-SB4004, AT-SB4008
SwitchBlade V2 AT-SB4004 V2, AT-SB4008 V2
AT-9800 AT-9812T, AT-9816GB
Rapier i Rapier 24i, Rapier 48i, Rapier 16fi
AT-8800 AT-8824, AT-8848
AT-8700XL AT-8724XL, AT-8748XL
AT-8600 AT-8624T/2M, AT-8624PoE
AR700 AR725, AR745, AR750S
AR400 AR440S, AR441S, AR450S