Install guide

WAN Load Balancing disable wanlb healthcheck 1-21
Software Version 2.7.5
C613-10454-00 REV A
disable wanlb healthcheck
Syntax DISable WANLB HEALthcheck
Description This command disables background healthchecking for resources. Under high
load, these resources may sometimes ignore ICMP healthchecks and be
marked as closing or down even though the resource is still operational and can
take connections. After executing this command, response times for resources
are set to zero. healthchecks are disabled by default.
Note that when healthchecks are disabled, the weighted-fast-response
algorithm used for selecting resources operates as the round-robin algorithm.
This is because all resources effectively have the same response time. Also, the
states of all resources will change to the states of their associated IP interface.
This is because WAN load balancer can no longer use the healthchecks to
determine the states of its resources.
Examples To disable the health checking, use the command:
ena wanlb heal
Related Commands enable wanlb healthcheck
show wanlb
show wanlb healthcheck