Install guide

WAN Load Balancing disable wanlb 1-19
Software Version 2.7.5
C613-10454-00 REV A
delete wanlb resource
Syntax DELete WANLB RESource={ALL|interface}
Description This command deletes a WAN load balancer resource. You can only delete the
resource when it is in the down state and there are no WAN load balancer
sessions assigned to it. To place the resource in the down state, use the disable
wanlb resource command.
Examples To delete the resource PPP0 use the command:
del wanlb res=ppp0
Related Commands add wanlb resource
disable wanlb resource
enable wanlb resource
set wanlb resource
show wanlb resource
disable wanlb
Syntax DISable WANLB
Description This command disables WAN load balancing.
Examples To disable WAN load balancing, use the command:
dis wanlb
Related Commands disable wanlb resource
enable wanlb
show wanlb
Parameter Description
RESource An existing IP interface for the resource. Valid interfaces are:
● eth (such as eth0, eth1)
● PPP (such as ppp0, ppp1)
To see a list of current valid interfaces, use the show interface
command.
The resource parameter specifies the resource that is to be deleted.
This resource must match an existing IP interface. If all is specified then
all resources will be deleted.