Install guide

1-12 Release Note
Software Version 2.7.5
C613-10454-00 REV A
8 add firewall policy=policy-name
interface=interface type={public|private}
Add the firewall policy to the
interfaces that the load balancer
will use.
9 add firewall policy=policy-name
nat={enhanced|standard} interface=interface
[ip=ipadd] gblinterface=interface
[gblip=ipadd[-ipadd]]
Add the firewall policy for NAT and
define the global IP addresses for
each interface. We recommend
using enhanced NAT when
configuring the WAN load balancer.
10 enable wanlb Enable the WAN load balancer.
11 add wanlb resource Add a WAN load balancer resource
to each port.
12 set wanlb [orphantimeout={off|1..65535}]
[select={roundrobin|
wleastconnect|wlottery|wfastresponse}]
Select the load balancing method
you require, or keep the default
settings.
13 add wanlb resource=interface
[weight={0..10000000|automatic|
perfectautomatic}]
If you have selected either
wleastconnect or wlottery, you
can select the weight options for
each of the WAN load balancer
interfaces.
Default weight: 10000
14 add wanlb healthcheck host=hostipadd You can now add your remote
healthcheck sites.
15 enable wanlb healthcheck You can now enable
healthchecking.
Table 1-1: WAN load balancing configuration procedure (Continued)
Step Commands Description