Install guide

78 VRRP Preemption Delay Release Note
Software Version 2.7.5
C613-10454-00 REV A
show vrrp
Syntax SHow VRRP[=vr-identifier]
Description This command displays information about the specified virtual router or all the
virtual routers in which the router or switch is participating.
Figure 18: Example output from the show vrrp command
Virtual Router Identifier ............. 1
Configuration:
VR MAC ADDRESS .................... 00-00-5E-00-01-01
Interface ......................... ppp0
Priority .......................... 255
State ............................. INITIAL
Authentication .................... None
Password .......................... NOT SET
IP Address(es) .................... 202.36.163.156
Advertisements .................... ON
Advertisement Interval ............ 1
Preempt Mode ...................... ON
Preempt Mode Delay (seconds)....... 60
Port Monitoring ................... ON
Step value ........................ 40
.
.
.
Table 22: New parameters in output of the show vrrp command
Parameter Meaning
Preempt Mode Delay
(seconds)
Period in seconds that the router or switch delays before
assuming the master role after it has determined that its
priority is greater than all other routers or switches. Valid
only when preempt mode is on.