Install guide

Software Version 2.7.5 77
Software Version 2.7.5
C613-10454-00 REV A
set vrrp
Syntax SET VRRP=vr-identifier [ADINTerval=1..255]
[ADOPTvrip={ON|OFF}]
[ADVertisements={ON|OFF|YES|NO|TRUE|FALSE}]
[AUTHentication={NONE|PLAINtext}] [PASSword=password]
[PORTMOnitoring={ON|OFF}
[STEPVALue={stepvalue|PRoportional}]]
[PREEmpt={ON|OFF}] [DELay=0
..3600] [PRIOrity=1..254]
Description The new delay parameter specifies the number of seconds that a higher
priority switch must wait before preempting a lower priority switch. The delay
parameter is valid only when the preempt parameter is on. The parameter
allows a delay of up to one hour (3600 seconds).
After the switch determines it has the highest priority, it waits the delay time,
and then assumes control. A delay can ensure that there is adequate time for
the master to update its routing tables before taking over. The default is 0 or off.
We recommend that all switches participating in the same virtual router be
configured with the same delay value. This should be the case if all switches
have an equal amount of routing information to update before becoming the
new master. Command checking does not enforce this because it cannot
determine the values of delays set on other switches. In some cases it may be
valid to have different values on different devices, and doing so does not affect
the delay function as long as the value covers the “worst case” time required to
fully update routing tables.
The pre-existing preempt parameter specifies whether a higher priority router
or switch preempts a lower priority router or switch acting as the master. If on,
preempt mode is used. The default is on. If this parameter is off, preemption
cannot occur; if any preemptions are in progress, they are immediately
cancelled.
The preferred master (with a priority of 255) always assumes the master role
when it is available, regardless of how the preempt parameter is set. Note that
all routers or switches participating in the same virtual router must be
configured with the same value for this parameter.