Install guide

Software Version 2.7.5 73
Software Version 2.7.5
C613-10454-00 REV A
show firewall session
Syntax SHow FIREwall SEssion[=session-number]
[POLIcy=policy-name] [COUnter] [IP=ipadd[-ipadd]]
[POrt={port[-port]|service-name}]
[PROTocol={protocol|ALL|EGP|GRE|ICmp|OSPF|TCP|UDP}]
[SUMmary] [UPNP]
where:
■ ipadd is an IP address in dotted decimal notation
Description This command displays information about the sessions and flows currently
active for the specified policy.
The new ip parameter specifies an IP address or a range of addresses. If you
specify ip, sessions that involve that IP address are displayed. The firewall
matches the specified IP address against the source and destination addresses
of packets on both the private and public interfaces.