Install guide

Software Version 2.7.5 45
Software Version 2.7.5
C613-10454-00 REV A
show ospf interface
Syntax SHow OSPF INTerface[=interface]
[AREa={BAckbone|area-number}] [IPaddress=ipadd]
[{FULl|SUMmary}]
Description This command displays information about OSPF interfaces. The existing Type
field displays the configured network type.
Figure 12: Example output from show ospf interface command for a specified interface
vlan1:
Status ........................ Enabled
Area .......................... Backbone
IP address .................... 192.168.250.1
IP net mask ................... 255.255.255.0
IP network number ............. 192.168.250.0
Type .......................... broadcast
OSPF on demand ................ ON (OFF)
Passive ....................... No
State ......................... otherDR
Router priority ............... 5
Transit delay ................. 1 second
Retransmit interval ........... 5 seconds
Hello interval ................ 10 seconds
Router dead interval .......... 40 seconds
Poll interval ................. 120 seconds
Interface events .............. 1
Authentication ................ Password (area default)
Password ...................... Charlie1
Designated router ............. 192.168.250.254
Backup designated router ...... 192.168.250.253
Metric boost 1 ................ 0
Table 15: Changed parameter in the output of the show ospf interface command for a
specific interface
Parameter Meaning
Type Type of network associated with the interface:
Broadcast
NBMA (non-broadcast multi-access)
Point-to-Point
Unknown
Virtual