Install guide

42 OSPF Network Types Release Note
Software Version 2.7.5
C613-10454-00 REV A
You can add, delete or modify static neighbours by using the commands:
add ospf neighbour=ipadd priority=0..255
delete ospf neighbour=ipadd
set ospf neighbour=ipadd
You can display the list of currently configured static neighbours using the
command:
show ospf neighbour
You can configure the time interval between hello messages sent to neighbours
that are deemed to be inactive. To do this, use the pollinterval parameter on
the add ospf interface and set ospf interface commands.
Neighbours on
broadcast networks
When you change the network type of an Ethernet or VLAN interface from
non-broadcast to broadcast:
■ Any existing statically defined neighbours are cleared.
■ Hello messages are sent as broadcast messages, so neighbours are
dynamically learned.
You can display the list of current neighbours using the command:
show ospf neighbour
Command Changes
The following table summarises the new and modified commands (see
Command Reference Updates).
Command Change
add ospf interface New network parameter
set ospf interface New network parameter
show ospf interface Existing Ty pe field displays the current setting of the new
network parameter