Install guide

Software Version 2.7.5 21
Software Version 2.7.5
C613-10454-00 REV A
show ip
Syntax SHow IP
Description This command displays general configuration information regarding the
router or switch (Figure 6 on page 21, Table 9 on page 21).
Figure 6: Example output from the show ip command
IP Module Configuration
------------------------------------------------------------
Module Status .................. ENABLED
IP Packet Forwarding ........... ENABLED
IP Echo Reply .................. ENABLED
Debugging ...................... DISABLED
IP Fragment Offset Filtering ... ENABLED
Default Name Servers
Primary Name Server .......... 192.168.1.1 (ppp0)
Secondary Name Server ........ Not Set
Name Server .................... 192.168.1.1 (ppp0)
Secondary Name Server .......... Not Set
Source-Routed Packets .......... Discarded
Remote IP address assignment ... DISABLED
DNS Relay ...................... DISABLED
IP ARP LOG ..................... ENABLED
IP ARP refresh by hit .......... ENABLED
.
.
.
Table 9: New parameter in output of the show ip command
Parameter Meaning
IP ARP refresh by hit Whether ARP entry refreshing is enabled.