Install guide

2-66 set ip routemap Release Note
Software Version 2.7.5
C613-10454-00 REV A
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion=INCLude] SET LOCalpref=0..4294967295
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion=INCLude] SET MED={0..4294967295|REMOVE}
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion=INCLude] SET METric=0..4294967295
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion=INCLude] SET ORIGin={IGP|EGP|INCOmplete}
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion=INCLude] SET TYpe={1|2}
SET IP ROUTEMap=routemap ENTry=1..4294967295
[ACtion={INCLude|EXCLude}] SET TAG=1..65535
Description This command does one of the following:
■ changes the action of an entry in a route map
■ modifies an entry’s match clause
■ modifies an entry’s set clause
This command does not create or delete an entry or clause. To create a new
entry or clause, use the add ip routemap command on page 2-49. To delete an
entry or clause, use the delete ip routemap command on page 2-59.
Parameters for both
match and set
clauses
Parameter Description
ROUTEMap The name of the route map that the entry or clause belongs to.
Default: no default
ENTry The ID number of the entry to change.
Default: no default
ACtion Whether matching prefixes or update messages are included or
excluded by the process that is using the route map.
The action parameter applies to the entire entry.
It is not meaningful to have action=exclude in an entry with a set
clause.
Default: the current setting. If there is no current setting, include