Install guide

WAN Load Balancing show wanlb resource 1-37
Software Version 2.7.5
C613-10454-00 REV A
show wanlb resource
Syntax SHow WANLB RESource[={ALL|interface}] [HEALthcheck]
Description This command displays information about all resources for the WAN load
balancer (Figure 1-6, Figure 1-7, Table 1-5). If a resource name is specified, the
output displays detailed information about the particular resource (Figure 1-8
on page 1-39, Table 1-6 on page 1-40).
Figure 1-6: Example output from the show wanlb resource command
Figure 1-7: Example output from the show wanlb resource command if no resources are
defined
Parameter Description
Resource The resource whose information is to be displayed, where interface is
a valid interface name formed by concatenating an interface type and
an interface instance. Valid interfaces are:
● eth (such as eth0, eth1)
● PPP (such as ppp0, ppp1)
To see a list of current valid interfaces, use the show interface
command.
HEALthcheck Displays detailed information about healthchecks for the specified
resource (Figure 1-9 on page 1-42, Table 1-7 on page 1-42).
Healthchecks are periodic checks of the health of a connection
between a resource and a selected remote host. The healthcheck
method involves transmitting an ICMP echo request and monitoring its
response.
WAN Load Balancer Resources
Resource Status State
---------------------------------------------------------
ppp0 DISABLED CLOSING
eth0 ENABLED UP
eth1 DISABLED DOWN
---------------------------------------------------------
WAN Load Balancer Resources
Resource Status State
---------------------------------------------------------
There are no resources
---------------------------------------------------------