Install guide

WAN Load Balancing show wanlb debug 1-35
Software Version 2.7.5
C613-10454-00 REV A
Example To display the current configuration and status of WAN load balancer, use the
command:
sh wanlb
Related Commands enable wanlb debug
enable wanlb healthcheck
disable wanlb debug
set wanlb
set wanlb abd
show wanlb debug
Syntax SHow WANLB DEBug
Description This command lists the types of WAN load balancer debugging that are
currently enabled (Figure 1-4, Tab le 1-3 ).
Figure 1-4: Example output from the show wanlb debug command
Table 1-3: Parameters in the output of the show wanlb debug command
Example To display the types of WAN load balancer debugging that are currently
enabled, use the command:
sh wanlb deb
Related Commands enable wanlb debug
disable wanlb debug
Decrease Threshold The maximum percentage that the bandwidth can decrease in one
update interval and still be updated as the resource's new weight. If
the maximum bandwidth detected for the last update interval has
decreased beyond the threshold, then the resource's weight is not
updated.
Traffic The resource traffic that is measured by automatic bandwidth
detection, one of TOTAL, INBOUND, or OUTBOUND.
Table 1-2: Parameters in the output of the show wanlb command (Continued)
Parameter Description
WAN Load Balancer Debug
----------------------------------------------
Debug ....................... RESOURCE, SELECT
Parameter Description
Debug The types of WAN load balancer debugging that are currently enabled;
one of All, None, or a list of the enabled types.