Install guide

WAN Load Balancing enable wanlb 1-23
Software Version 2.7.5
C613-10454-00 REV A
enable wanlb
Syntax ENAble WANLB
Description This command enables the WAN load balancer. Although you do not need to
enable the WAN load balancer to configure its settings, you do need to enable it
to run the WAN load balancing operation.
You cannot enable the WAN load balancer when equal cost multipath routing
is also enabled. To disable equal cost multipath routing, use the disable ip
route command.
Examples To enable WAN load balancer, use the command:
ena wanlb
Related Commands disable wanlb
set wanlb
show wanlb