Install guide

Software Version 2.8.1 79
Software Version 2.8.1
C613-10477-00 REV B
Table 19: New and changed parameters in the output of the show ip udp command
Parameter Meaning
Local
Address
The IP address of the last interface that was used to transport UDP packets from
the router or switch, for a given process. An address of 0.0.0.0 indicates that the
UDP session is active, but either no packets have been transmitted yet, or packets
have been transmitted without specifying the source IP address.
Process The process that is using the UDP session. The following process types may use
UDP on the router or switch:
NTP Time synchronisation using the Network Time Protocol
LB Load Balancing
RSVP Quality of Service determination using the Resource Reservation
Protocol
UPNP Universal Plug and Play
VOIP Voice over IP
L2TP Tunnelling of PPP Link Layer data using the Layer 2 Tunnelling
Protocol
X25 The X25 protocol
SYSLOG Generation/reception of syslog type logs
SRLP LOG Generation/reception of logs using the Secure Router Log
Protocol
NETM LOG Generation/reception of logs using the Net Manage protocol
TFTP Download/upload of files using the Trivial File Transfer Protocol
SNMP Transfer of device management data using the Simple Network
Management Protocol
DHCP SVR External network node configuration by the router or switch
acting as a Dynamic Host Configuration Protocol Server
DHCP CLT Communications by the router or switch when acting as a client,
using the Dynamic Host Configuration Protocol
BOOTP Communications by the router or switch when acting as a BOOTP
Relay Agent
UDP FWD Forwarding of UDP packets to an external device using IP Helper.
DNS Hostname resolution using the Domain Name System Protocol
DNS RELAY The relaying of DNS messages from the router or switch to an
external host
RIP Routing of IP packets using the Routing Information Protocol
IKMP Secure communications using the Internet Security Association
and Key Management Protocol
IKMP NAT Secure communications using the Internet Security Association
and Key Management Protocol via devices configured using
Network Address Translation
IPSEC Secure communications using the IP Security Protocol
TACACS User authentication using the Terminal Access Controller Access
Control System protocol
RADIUS User authentication using the Remote Authentication Dial In User
Service Protocol
RAD ACC Accounting using the RADIUS protocol