Install guide

Software Version 2.8.1 23
Software Version 2.8.1
C613-10477-00 REV B
Example To permanently direct all debug output from the BGP module to a file named
bgp.txt, use the command:
cre fi=bgp.txt com="enable bgp debug=all" perm
reset file permanentredirect
Syntax RESET FIle[=filename] PERManentredirect
Description This new command closes one or all text files so that they no longer receive
input from commands or scripts. After the file closes, it can be uploaded or
edited
Example To reset the bgp.txt file so that it no longer receives output from the enable bgp
debug=all command (previously set), use the command:
reset fi=bgp.txt perm
show file permanentredirect
Syntax SHow FIle[=filename] PERManentredirect
Description This new command displays information about one text file or all that are
permanently receiving output from commands or scripts (Figure 3, Ta ble 2).
These files are typically created to collect data during debugging.
The file parameter displays information about a specific text file (Figure 4). The
filename option is in the format [device:]filename.txt and can be:
■ uppercase and lowercase letters
■ digits
■ # $ % & ! ' ( ) + , - . ; = @ [ ] ^ _ ` { } ~ and space
Device indicates the physical location where the file is stored. The default is
flash.
LIMIT A decimal number from 0 to 1048 576 bytes specifying the maximum
file size.
Default: 204 800 bytes
Parameter Description (cont.)
Parameter Description
FIle Name of the text file to close. If no file is specified, all text files are
closed.
The filename is in the format [device:]filename.txt and can be:
• uppercase and lowercase letters
• digits
• # $ % & ! ' ( ) + , - . ; = @ [ ] ^ _ ` { } ~ and space
device indicates the physical location where the file is stored. The
default is flash.
Default: no default