Install guide

Ethernet Protection Switching Ring (EPSR) set epsr port 27
create snmp community (SNMPv1 & v2)
create epsr
show epsr
set epsr port
Syntax SET EPSR=epsr-name POrt=port TYpe={PRIMary|SECOndary}
Description This command sets or changes primary and secondary port designations for a
selected EPSR instance. Setting one port to primary will automatically cause
the other port to change to secondary; similarly setting one port to secondary
will automatically cause the other port to change to primary.
This command is only valid if the switch is acting as the master node for the
selected an EPSR instance. To set the mode for an EPSR instance, use the create
epsr command on page 1-17. To view the mode for an EPSR instance, use the
show epsr command on page 1-28.
An EPSR port can only be set when the EPSR is in the disabled state on the
switch. To disable an EPSR instance, use the disable epsr command on
page 1-21.
If a ring port for the EPSR instance is also a member of a trunk group, you can
run this command by entering any one of the ports within the trunk group.
Examples To set port 1 to be a primary port for the EPSR instance called blue, use the
command:
set epsr=blue po=1 ty=prim
Related Commands create epsr
show epsr
Parameter Description
EPSR The EPSR to be set for the port.
Default: no default
epsr-name The name of the EPSR instance. This can be a character
string, 1 to 15 characters long. Valid characters are
uppercase letters (A-Z), lowercase letters (a-z), digits (0-
9), the underscore character ("_"), the hyphen character
("-"). The epsr-name cannot be ALL.
ALL All EPSR instances.
POrt The number of the port to have its primary or secondary designation
set to the specified type. The port must already be in the EPSR instance.
Default: no default
TYpe The port’s role within the EPSR ring.
Default: no default
PRIMary The port is the primary port.
SECOndary The port is the secondary port. When the EPSR ring is
complete, the secondary port will be blocked for all data
VLANs within the ring domain.