Install guide

Software Version 2.8.1 195
Software Version 2.8.1
C613-10477-00 REV B
enabled on a particular device, no other debugging mode can be enabled on
any other device simultaneously.
CDP debugging is disabled by default.
enable lldp cdp interface
Syntax ENAble LLDP CDP INTerface=interface
where interface is the interface on which to enable CDP, one of:
■ ethn
An Eth port, where n is the Eth port instance (for example, eth0)
■ portm
A switch port, where m is the port number (for example, port2 for the
switch port numbered 2)
■ pppm
A PPP interface, where m is the interface number
Description This command enables CDP on the specified interface, which has been
previously disabled using the disable lldp cdp interface command. For the
specified interface only, the reception of CDP advertisements begins, and
neighbour entries are added as they are discovered.
CDP is enabled by default for all interfaces, but you must first enable CDP,
using the enable lldp cdp command.
enable lldp cdp ppptemplate
Syntax ENAble LLDP CDP PPPTemplate=template
Where template is a number from 0 to 31
Description This new command enables CDP listening on interfaces that are dynamically
created using the specified PPP template.
By default, when CDP has been enabled using enable lldp cdp, CDP listening
is enabled for any dynamically created PPP interface.
Example To enable CDP listening for PPP template number 3, use the command:
ena lldp cdp pppt=3
Parameter Description
DEBug The debugging mode to enable.
PACket Enables debugging of the reception of CDP
advertisements.
ADJacency Enables debugging of the creation and deletion of CDP
neighbours
EVent Enables debugging of error conditions, such as bad
packets.
PPP Enables debugging of PPP events.