Install guide

192 SNMP MIBs Release Note
Software Version 2.8.1
C613-10477-00 REV B
Command Reference Updates
This section describes the changed portions of the modified command and
output screen. For modified commands and output, the new parameters,
options, and fields are shown in bold.
show buffer
Syntax SHow BUFfer [SCAn[=address [QUEuepointers]]]
where address is the memory address of a section of router or switch code
expressed in hexadecimal
Description The output of this command includes a new field.
Figure 63: Example output from the show buffer command
Memory ( DRAM ) .......... 16384 kB
Free Memory .............. 48 %
Free fast buffers ........ 1799
Total fast buffers ....... 1802
Free buffers ............. 4013
Total buffers ............ 4096
Buffer level 3 ........... 125 (don’t process input frames)
Buffer level 2 ........... 250 (don’t do monitor or command output)
Buffer level 1 ........... 500 (don’t buffer up log messages)
Buffer level 0 ........... 1500 (warning via snmp trap)
Table 54: New parameters in output of the show buffer command
Parameter Meaning
Buffer level n When the “Free buffers” value drops below this level, the
specified activity ceases or an SNMP trap is generated.