Install guide

Software Version 2.8.1 137
Software Version 2.8.1
C613-10477-00 REV B
Figure 39: Example output of the modified show qos policy command
show qos port
Syntax SHow QOS POrt[={port-list|ALL}] [EGRessqueue=queue-list]
Description This command displays QoS information about ports and now includes
information about port groups (bold in example below).
Identifier .................. 1
Description ................. all ports
TCs Assigned ................ 5,7,22,31-33
Port(s) Assigned to ......... 1-24
Port Group(s) Assigned to ... 1(1-12)
2(13-24)
Trunk(s) Assigned to ........ None
Default Traffic Class:
Minimum Bandwidth ......... None
Minimum Burst Size ........ 0 B
Maximum Bandwidth ......... 10 Mbps
Maximum Burst Size ........ 64 kbyte
Drop BandwidthClass3 ...... YES
Ignore BandwidthClass ..... YES
Premarking ................ USEMARKVALUE
Remarking ................. UESDSCPMAP
Mark value ................ 0
Action .................... SENDVLANPORT
VLAN .................... 2
PORT .................... 4
Storm Protection:
Status .................. ENABLED
Action .................. PORTDISABLE
Rate .................... 1kbps
Window .................. 100ms
Timeout ................. None
Table 32: New parameters in output of the show qos policy command
Parameter Meaning
Port Group(s) Assigned to ID of the port group that is assigned to the policy.
Trunk(s) Assigned to Trunks to which the policy has been assigned.
Status Whether storm protection is enabled for the default traffic
class.
Action Whether the port is administratively or operationally
disabled when the volume of traffic exceeds the rate.
Rate Allowable traffic volume before action is executed.
Window Interval in milliseconds between checking the traffic class
for storms.
Timeout Length of time in seconds that the port remains disabled
after having been disabled by storm protection.