Install guide

Software Version 2.8.1 113
Software Version 2.8.1
C613-10477-00 REV B
MLD Snooping Group Membership Display
The command show mldsnooping no longer displays the port members of the
All Routers group in the list of ports for groups other than the All Routers
group. This change makes the output of this command more like output from
the command show igmpsnooping.
To illustrate the change, an example of the previous output is shown in
Figure 32 on page 116, and an example of the new output is in Figure 33 on
page 116.
Command Changes
The following table summarises the modified command:
Change of Maximum Query Response Interval for
MLD
This Software Version changes the valid range for the MLD query response
interval. The maximum interval is now 8387 seconds, in accordance with
RFC 2710.
To set the query response interval, use the command:
set ipv6 mld qrinterval=1..8387
Note that if the router or switch acts as an MLDv1 querier and qrinterval is set
to more than 65 seconds, then the Maximum Response Code in MLDv1 query
packets will be set to 65535 milliseconds, because this is the highest valid value
for that field.
Command Changes
The following table summarises the modified command:
Command Change
show mldsnooping More consistent output
Command Change
set ipv6 mld Changed range for qrinterval parameter.