AT-8800 SERIES SWITCH QUICK INSTALL GUIDE Software Release 2.6.
AT-8800 Series Quick Install Guide Document Number C613-04043-01 REV A Copyright © 2003 Allied Telesyn International, Corp. 19800 North Creek Parkway, Suite 200, Bothell, WA 98011, USA. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn. Allied Telesyn International, Corp. reserves the right to make changes in specifications and other information contained in this document without prior written notice.
Quick Install Guide 3 Documentation Roadmap AT-8800 Series General Customer Support AT-8800 Series Safety and Statutory Information Booklet Visit www.alliedtelesyn.co.nz for the latest documentation, FAQs, and support information.
AT-8800 Series Selecting a Site The switch can be installed in a standard 19-inch rack or on a level surface such as a desktop or bench. When installing the switch, choose a site that: ■ Allows adequate airflow around the switch and its vents. ■ Is free of dust and moisture. ■ Will maintain an ambient temperature range of 0-40º C (32-104º F) and a humidity range of 5-95% non-condensing. ■ Has a reliable and earthed (grounded) power supply circuit, preferably dedicated and filtered.
Quick Install Guide 5 6. Apply AC power to the switch Plug the power cord into the AC power connector on the switch’s rear panel, as shown in Figure 1. The FAULT LED may light for one or two seconds as the switch runs internal tests. If the LED remains lit, refer to the AT-8800 Series Hardware Reference for troubleshooting information. Figure 1: AT-8848 front panel and rear panel with AC power inlet.
AT-8800 Series Configuring the Switch Some configuration is necessary if you wish to enable the switch’s advanced switching capabilities. The switch can be configured via the Command Line Interface (CLI) or Graphical User Interface (GUI). Using the CLI to configure a switch 1. Connect a terminal or PC to ASYN0 (RS-232) Using the supplied RJ-45 to DB9F cable, connect your terminal or PC to the ASYN0 port on the switch’s front panel. 2.
Quick Install Guide 7 To display a list of help topics, enter: help To display help on a specific topic, enter: help topic Alternatively, type a question mark (?) at the end of a partially completed command to see a list of valid options. See the AT-8800 Series Software Reference for more information on configuring the switch.
AT-9800 Series The System Status page is displayed. Select options from the sidebar menu to configure and manage the switch. For context-sensitive online help, click on the Help button at the top of the sidebar menu or on any pop-up page. System LEDs Table 2: System LEDs for AT-8800 Series switches. LED State Function RPS (Redundant Power Supply) Green An RPS is connected to the switch and is supplying power. FAULT Red The switch or management software is malfunctioning. PSU fail.
