Specifications

Hardware Reference 23
C613-03064-00 REV E
Table: 14 AT-A40/SC, AT-A40/MT, AT-A41/SC and AT-A41/MT LEDs.
LED State Function
Activity/Link/Fault Green A link is open and the port is enabled
Flashing green 100 Mbps activity is occurring
Flashing amber
(and lower LED is Off)
The link has failed at the remote end
Off No link is present
Full Dup/Half
Dup/Col
Green The port is operating at full-duplex
Amber The port is operating at half-duplex
Flashing amber Collisions are occurring
Off No link is present
Both LEDs Alternate flashing of
upper and lower LED,
amber
The switch does not support this model of
uplink module
Table: 15 AT-A42/GBIC LEDs .
LED State Function
L/A
Link/Activity
Green A 1000 Mbps link is open
Flashing green 1000 Mbps activity is occurring
Flashing amber
(and GBIC LED is Off)
A TX fault has occurred
Off No link is present
GBIC Green The switch has recognised the GBIC,
the GBIC is a valid model
Green
(and L/A LED is flashing
GREEN)
The port is operating at full-duplex
Amber
(and L/A LED is OFF)
The switch has not recognised the
GBIC, the GBIC is not a valid model
Amber
(and L/A LED is flashing
GREEN)
The port is operating at half-duplex
Flashing amber
(and L/A LED is flashing
GREEN)
Collisions are occurring
Off No GBIC is installed, or a TX fault has
occurred
Both LEDs Slow alternate flashing of
L/A and GBIC LED, amber
The switch has not recognised the
GBIC, or the GBIC is not a valid model