Specifications

20 AT-8700XL Series
C613-03064-00 REV E
Figure 9: Example output from the SHOW TEST command.
10/100 Ethernet LAN Port Tests
A loopback plug is required to run the first part of the Ethernet LAN test. See
“Loopback Plugs for Testing Switch Interfaces” on page 22 for details of how to
make a loopback plug. To start an Ethernet interface test, use the command:
ENABLE TEST INT=PORTn
where n is the Ethernet interface number. The test will run for 4 minutes. Use
the SHOW TEST command to observe the test progress.
Troubleshooting
This section provides information on how to detect and resolve problems with
AT-8700XL Series switches and their expansion options.
Other sources of useful troubleshooting information are:
■ www.alliedtelesis.com/support/software.
■ The AT-8700XL Series Software Reference.
Board ID Bay Board Name Rev Serial number
----------------------------------------------------------------------------
Base 108 8724 AT-8724XL M1-1 6845425
Uplink 88 1 AT-A35SX/SC-00 P1-0 14269019
Duration Details
Interface State Result Type (minutes) Data( %OK ) Control
----------------------------------------------------------------------------
port1 no test - - - - - -
port2 no test - - - - - -
port3 no test - - - - - -
port4 no test - - - - - -
port5 no test - - - - - -
port6 no test - - - - - -
port7 no test - - - - - -
port8 no test - - - - - -
port9 no test - - - - - -
port10 no test - - - - - -
port11 no test - - - - - -
port12 no test - - - - - -
port13 no test - - - - - -
port14 no test - - - - - -
port15 no test - - - - - -
port16 no test - - - - - -
port17 no test - - - - - -
port18 no test - - - - - -
port19 no test - - - - - -
port20 no test - - - - - -
port21 no test - - - - - -
port22 no test - - - - - -
port23 no test - - - - - -
port24 no test - - - - - -
port26 no test - - - - - -
asyn0 no test - - - - - -
----------------------------------------------------------------------------