Install guide

Software Version 2.7.6 59
Software Version 2.7.6
C613-10462-00 REV A
The applyto parameter specifies where the monitoring for this device applies.
If you specify private, the firewall copies packets at the private interface. This
is before firewall processing for outgoing packets and after firewall processing
for incoming packets. If you specify public, the firewall copies packets at the
public interface. This is before firewall processing for incoming packets and
after firewall processing for outgoing packets. If you specify both, the firewall
copies packets at both the public interface and the private interface. The default
is private.
The combination of ip and applyto uniquely identifies a monitor. For example,
you can create different monitors to monitor the same IP address on the private
and the public interfaces.
Example To change Monitor 1 so that it sends copied packets out over vlan3, use the
command:
add fire mo=1 cop=vlan3
set firewall policy
Syntax SET FIREwall POLIcy=policy-name
[ICMPUnreachabletimeout=seconds]
[MACCachetimeout=max-age] [MAXUPNPPORTMAPS={0..1000}]
[OTHERTimeout=minutes] [RADIuslimit=number
[TCPTimeout=minutes] [UDPTimeout=minutes]
[UPNP={ON|OFF|YES|NO|ENABLED|DISABLED}]
where seconds is an integer from 0 to 65535
Description The new icmpunreachabletimeout parameter specifies the delay before the
firewall deletes a session after it receives an ICMP unreachable message for
that session. The default is 0 seconds, which means the firewall deletes the
associated session immediately.
If you are configuring the firewall to allow Xbox Live sessions, increase this
timeout to a few seconds, for example, 20. Otherwise you may be unable to
connect to remote Xboxes that are also behind a firewall.