Install guide

34 Redistributing BGP Routes into RIP Release Note
Software Version 2.7.6
C613-10462-00 REV A
Overview of Filtering for RIP Routes
When the router or switch runs RIP, it receives routing information from
neighbouring routers, and can advertise RIP, BGP, statically-configured and
interface routes to neighbouring routers. You can filter routing information at
the processing points shown in the following figure.
For more information, see the Filtering IP Routes chapter of the Software
Reference.
Command Change Summary
The following table summarises the modified commands (see Command
Reference Updates).
Command Change
add ip rip redistribute New command
delete ip rip redistribute New command
set ip rip redistribute New command
add ip routemap A subset of existing parameters are valid when
importing BGP routes into RIP. Also, the metric
parameter can now specify a RIP metric
set ip routemap A subset of existing parameters are valid when
importing BGP routes into RIP. Also, the metric
parameter can now specify a RIP metric
incoming RIP
filtered by list of IP route filters
Routing Information Base (RIB)
ip-route-filter-rip
RIP
neighbour
outgoing RIP
RIP
neighbours
interface
and
static routes
exporting
turned on with
set ospf rip
OSPF routes
filtered by route map
applied using
add rip interface redistribute
BGP routes
The filtering router or switch