Install guide

Software Version 2.7.6 23
Software Version 2.7.6
C613-10462-00 REV A
Examples To specify ports 1-4 as trusted ports, use the command:
set dhcps po=1-4 tr=yes
To set the subscriber-id of port 10 to “user 480105”, use the command:
set dhcps po=10 subs="user 480105"
To remove the subscriber-id for port 10, use the command:
set dhcps po=10 subs=""
show classifier
SHow CLASSifier[={rule-id|ALL}]
Description If a classifier specifies dhcpsnooping for the source MAC address or source IP
address, this is displayed in the command output, as shown in the following
example.
Figure 7: Example output from the show classifier command
Classifier Rules
------------------------------------------------------------
Rule .................. 1
D-MAC Address ........ ANY
S-MAC Address ........ ANY
M-Type ............... ANY
S-VLAN ............... ANY
E-Format ............. ANY
Protocol ............. IP
TPID ................. ANY
VLAN Priority ........ ANY
S-IP Address ......... DHCPSNOOPING
D-IP Address ......... ANY
IP Protocol .......... ANY
TOS/DSCP ............. ANY
------------------------------------------------------------