Install guide

ManualsBrandsAllied Telesis ManualsSwitchAT 8648T/2SP

20 DHCP Snooping Release Note

Software Version 2.7.6

C613-10462-00 REV A

set classifier

Syntax:

non-IPv6 traffic

SET CLASSifier=rule-id

[MACSaddr={macadd|ANY|DHCPSnooping}]

[MACDaddr={macadd|ANY}]

[MACType={L2Ucast|L2Mcast|L2Bcast|ANY}] [TPID=tpid|ANY]

[VLANPriority=0..7|ANY] [VLAN={vlanname|1..4094|ANY}]

[INNERTpid=tpid|ANY] [INNERVLANPriority=0..7|ANY]

[INNERVLANId=VLAN=1..4094|ANY]

[ETHFormat={802.2-Tagged|802.2-Untagged|ETHII-Tagged|

ETHII-Untagged|NETWARERAW-Tagged|Netwareraw-untagged|

SNAP-Tagged|SNAP-Untagged|ANY}]

[PROTocol={protocoltype|IP|IPX|ANY}]

[IPDScp={dscplist|ANY}] [IPTOs={0..7|ANY}]

[IPSAddr={ipaddmask|ANY|DHCPSnooping}]

[IPDAddr={ipaddmask|ANY}]

[IPPRotocol={TCP|UDP|ICMp|IGMp|ipprotocolnum|ANY}]

[IPXDAddr={ipxadd|ANY}]

[IPXDSocket={NCP|SAP|RIP|NNB|DIAg|NLSp|IPXwan|

ipxsocketnum|ANY}]

[IPXSSocket={NCP|SAP|RIP|NNB|DIAg|NLSp|IPXwan|

ipxsocketnum|ANY}]

[TCPSport={portid|port-range|ANY}]

[TCPDport={portid|port-range|ANY}]

[UDPSport={portid|port-range|ANY}]

[UDPDport={portid|port-range|ANY}]

[L4SMask=mask|ANY] [L4DMask=mask|ANY]

[L5BYTE01=byteoffset,bytevalue[,bytemask]]

[L5BYTE02=byteoffset,bytevalue[,bytemask]]

[L5BYTE03=byteoffset,bytevalue[,bytemask]]

[L5BYTE04=byteoffset,bytevalue[,bytemask]]

[L5BYTE05=byteoffset,bytevalue[,bytemask]]

[L5BYTE06=byteoffset,bytevalue[,bytemask]]

[L5BYTE07=byteoffset,bytevalue[,bytemask]]

[L5BYTE08=byteoffset,bytevalue[,bytemask]]

[L5BYTE09=byteoffset,bytevalue[,bytemask]]

[L5BYTE10=byteoffset,bytevalue[,bytemask]]

[L5BYTE11=byteoffset,bytevalue[,bytemask]]

[L5BYTE12=byteoffset,bytevalue[,bytemask]]

[L5BYTE13=byteoffset,bytevalue[,bytemask]]

[L5BYTE14=byteoffset,bytevalue[,bytemask]]

[L5BYTE15=byteoffset,bytevalue[,bytemask]]

[L5BYTE16=byteoffset,bytevalue[,bytemask]]

Description The new dhcpsnooping option for the macsaddress and ipsaddress

parameters applies the classifier to entries in the DHCP snooping binding

database.

The macsaddress parameter specifies the source MAC address of the packets.

The ipsaddress parameter specifies the source IP address of the packets.