Specifications

Features in 291-11 59
Version 291-19
C613-10488-00 REV R
CR00018751 Firewall 2 The firewall sometimes rebooted when using ENAPT, especially if FTP was
being run though the firewall.
This issue has been resolved.
YYYYYY––––Y
CR00018752 Switch 2 An AR770S router could reboot when it was processing a very heavy traffic
load in its CPU.
This issue has been resolved.
––Y––––––––
CR00018941 IP Gateway 2 When deleting an IP RIP interface or disabling an IP interface with RIP
running on it, the router or switch would stop responding and reboot after
5 minutes.
This issue has been resolved.
YYYYYYYYYYY
CR00018943 Switch 2 With 1000Base SFPs installed, the AR770S Eth ports failed to establish a link
on restarting when receiving a moderate amount of traffic.
This issue has been resolved.
––Y––––––––
CR00019273 BGP 2 Once a BGP peer had received updates from another peer, it was not
possible to use the commands delete bgp net or delete bgp import to
remove a locally-imported route from the BGP RIB.
This issue has been resolved. These commands will now work at all times.
YYYYYY––YYY
CR00019351 TPAD, X25T 2 Multiple concurrent TPAD transactions could cause the router or switch to
reboot.
This issue has been resolved.
YYYYY––––––
CR00019542 Eth 2 With some link partners, an AR415S Ethernet port would stop receiving
packets after some hours or days, and a link state cycle or interface reset
was required to restore operation.
This issue has been resolved.
Y––––––––––
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800