Specifications

Features in 291-16 25
Version 291-19
C613-10488-00 REV R
CR00022596 Port
Authentication
2 Previously on an AR-770s, the command:
enable portauth=8021x port=portid type=authenticator
guestvlan=vlanid
would not add the specified port to the specified guest VLAN if executed
from the device boot configuration script.
This issue has been resolved.
––Y––––––––
CR00022647 BOOTP 2 Previously if a router or switch acting as a BOOTP relay had two subnets,
and one was a super net of the other, the router or switch could forward
DHCP messages with the broadcast flag set to the wrong interface. This
issue has been resolved.
YYYYYYYYYYY
CR00022985 L2TP 2 Previously, under some heavy load traffic conditions, L2TP tunnels would
experience a periodic latency or sometimes no longer function. This issue
has been resolved.
YYYYYY––YYY
CR00022993 PIMv4 2 Previously on specific network configurations, using PIM Sparse Mode
could cause a memory leak. This issue has been resolved.
YYYYYYY–YYY
CR00023012 IP 2 A security vulnerability was found in the design of the DNS protocol. This
vulnerability has been resolved.
YYYYYYYYYYY
CR00023053 BGP 2 A security vulnerability was found in the implementation of BGP. This
vulnerability has been resolved.
YYYYYY––YYY
CR00023082 RADIUS 2 RADIUS servers can specify multiple dynamic routes to a user, in addition to
the normal host specific route to the allocated address. These additional
routes are called framed-routes in RADIUS configuration definition.
Previously, the maximum number of framed-routes that could be created
by the RADIUS server on the router or switch were limited to 2 per client.
This limit has increased to 32 routes.
YYYYYYYYYYY
CR Module Level Description
AR44x / AR450 AR7x5 AR750S / AR770S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL AT-8948 / x900-48 AT-9900 AT-9800