Specifications

26 AT-8600 Series
C613-03080-00 REV G
10/100 Ethernet LAN Port Tests
A loopback plug is required to run the first part of the Ethernet LAN test. See
“Testing Switch Interfaces” on page 27 for details of how to make a loopback
plug. To start an Ethernet interface test, use the command:
enable test int=portn
where n is the Ethernet interface number. The test runs about 4 minutes. You
can use the following command to display the test progress and results:
Display test results with the command:
show test
The following figure shows example output from the this command.
Figure 6: Example output from the show test command
Board ID Bay Board Name Rev Serial number
----------------------------------------------------------------------------
Base 238 8624 AT-8624T/2M M1-1 12345678912345
Uplink 88 1 AT-A46 P1-0 98765432198765
Duration Details
Interface State Result Type (minutes) Data( %OK ) Control
----------------------------------------------------------------------------
port1 no test - - - - - -
port2 no test - - - - - -
port3 no test - - - - - -
port4 no test - - - - - -
port5 no test - - - - - -
port6 no test - - - - - -
port7 no test - - - - - -
port8 no test - - - - - -
port9 no test - - - - - -
port10 no test - - - - - -
port11 no test - - - - - -
port12 no test - - - - - -
port13 no test - - - - - -
port14 no test - - - - - -
port15 no test - - - - - -
port16 no test - - - - - -
port17 no test - - - - - -
port18 no test - - - - - -
port19 no test - - - - - -
port20 no test - - - - - -
port21 no test - - - - - -
port22 no test - - - - - -
port23 no test - - - - - -
port24 no test - - - - - -
port26 no test - - - - - -
asyn0 no test - - - - - -