User guide

Setting Up Fault Management Event View
912
AlliedView NMS Administration Guide
9.1.2 Task Overview
The following table lists the tasks that can be done at the Application interface. If you are using NMS, use the Screen Name
as well to locate the relevant section. For all menu options, refer to the AlliedView NMS User Guide Appendix.
9.2 Event View
This Event Viewer gets displayed on selecting the Network Events node under Fault Management in the AlliedView NMS
Client Tree as shown in the following figure.
FIGURE 9-2 Network Events Main Panel
Refer to the AlliedView NMS User Guide for general information on navigating in the view and using the search tool.
9.3 Configuring Trap Parsers
Configuring a Trap Parser is done to create and refine the information received from a trap (a specific unsolicited report by
a device).
Configuring Trap Parsers can be done by using the information in the MIB to set the match criteria or defining the
configuration and saving it to a file. (This requires that the MIB has been configured to include the traps. Refer to Section 11.)
TABLE 9-1 Task List for Fault Management
Task Form/Screen Name (if Applicable) Section
Review Events Screen Network Events (9.2)
Configure Trap Parsers Telesis Trap Parser Configuration (9.3)
Configure Event Parsers Telesis Event Parser Configuration (9.4)
Configure Event Filters Telesis Event Filter Configuration (9.5)
Review Alarm Screen Alarms (9.7)
Alarm Propagation Alarms (9.8)
Configure Alarm Filters Telesis Alarm Filter Configuration (9.9)
Configure System Logs (System Log Configuration) (9.6)
Alarm Retrieval During (Re)Discovery Retrieve Alarms (9.10)