User guide

Provisioning the iMG/RG iMG/RG Diagnostic Features
881
AlliedView NMS Administration Guide
FIGURE 7-214 LAN Diagnostics Tab for MOD-type iMG
Initially the table displays each LAN port on the iMG and its current status.
Not all modules include a Glan interface; if the Glan interface is not present, the Glan row will be omitted from the table.
The current status consists of ID, Speed, Status (enabled/disabled), and Connected (true/false). These are polled from the
device and updated approximately every 30 seconds while the tab is displayed.
With each port is a “Test” button and a “Test Result” field. The Test buttons can be checked or unchecked to select
individual ports for diagnosis. The “All” button is a shortcut to conveniently check or uncheck all interfaces.
The selected ports will be diagnosed when the “Diagnose Interface” button at the bottom of the panel is activated. The
operation will take several seconds.
Note: Testing all interfaces at once will increase the duration of the test and possibly interrupt CPE LAN service, so normally test one
interface at a time or small groups at a time rather than all interfaces at one time.
Since CPE LAN service may be interrupted during diagnosis, user confirmation is required before the operation will be
performed, as shown in the following figure.
FIGURE 7-215 Warning when Diagnosing LAN Ports
While diagnosis is underway, the test results display “Working” as shown below.