User guide

Provisioning the iMG/RG Provisioning an iMG/RG with the LAN4 Feature
876
AlliedView NMS Administration Guide
2. Note in the iMG/RG list that the device has all of the profiles dropped and the IP address is appended with _OLD, since
the IP address is now released. Refer to the following figure.
FIGURE 7-206 iMG De provisioned
7.12.6.2 Pre-provision the iMG for ADSL Management
3. If not done already, create profiles for the iMG. If the service/VLAN configuration is the same, the only profile that is
different is the General Profile, with the Port Assignments tab having port 4 not set to Management.
4. Fill in the Triple Play Form with the profiles, and select an ADSL port for the Slot.Port, as shown in the following figure.
FIGURE 7-207 Triple Play for ADSL Mgmt
7.12.6.3 Connect the iMG and Power On
5. Connect the customer equipment to one or more LAN ports 1, 2, 3, and 4.
6. Plug the uplink ADSL into the ADSL port.
7. Power on the iMG.
8. Wait and observe how the iMG is discovered, an IP address is found, and the profiles are applied. Refer to the following
figure.