User guide

Provisioning the iMG/RG Installation Procedures
839
AlliedView NMS Administration Guide
FIGURE 7-163 Using telnet to Access the RG
7. Login to the iMG/RG.
8. Set back to factory defaults (>sys config set factory)
9. You can now unplug the RG and place it back in its box.
10. Return to the De-Provision Ports Form.
11. This time select the Ports panel.
12. Right click on the iMG/RG and select Delete Object and Traces, as shown in the following figure.
FIGURE 7-164 Delete RG-Port Association (Delete Object and Traces)
13. When the RG is reconnected, the default VLAN for the RG is used at the start for DHCP discovery. Therefore, this
would most likely be for connecting the RG to an iMAP that is in any Access Island than where it was de-provisioned.
14. END OF PROCEDURE
7.10.9.4 De provision the iMG/RG (Open Access)
In the Open Access Model, it is the use of the RGMgmt VLAN that determines the strategy to follow: