User guide

Provisioning the iMG/RG Installation Procedures
821
AlliedView NMS Administration Guide
FIGURE 7-144 Add Voice Line (line 1)
15. Click on the now activated Add.
16. Back on the Status tab, click on Update Customer Info.
17. Note the results.
18. End of Procedure
Note: For the Open Access Model, the same procedure would be used, with the administrator ensuring that there was no conflict in
VLAN configuration between the iMG/RG General Profile and the Voice Service Profile.
7.10.5.3 Add Second Voice Line
1. Ensure the prerequisites are met:
• The Voice Profile already supports more than one voice line.
2. Find the iMG/RG for the customer in the iMG/RGs table using various methods:
• Bring up the iMG/RGs node in the Network Inventory table and do a search (Ctrl-F) on the Customer ID.
• Bring up the Ports node in the Network Inventory table and do a search (Ctrl-F) on the Customer ID.
3. Right click on the iMG/RG or Port and select View/Modify Details. This brings up the Triple Play Service Management
screen.
4. The Select tab should appear by default.
5. Click on Add Voice Line. The Add Voice Line form appears.
6. In the Add Voice Line form, note that the Voice Endpoint (used for DNS) is already defined, as well as the interface
group. These were defined in the Voice service profile.
7. Select from the pull-down the Voice Endpoint Port, the Line Profile, and the CRV. Refer to Figure 7-145.
Note: Since this is a second voice line, choose TEL2 for the Voice Endpoint Port; otherwise any new values chosen here will change
the already existing voice endpoint.