User guide

Provisioning the iMG/RG Installation Procedures
809
AlliedView NMS Administration Guide
• Have an iMG/RG General Profile with a name such as “DVLK-AI01-Vacant” and include scoping so that when it is used
only iMAPs from AI01 are accessible. Refer to Figure 7-135, Figure 7-136, and Figure 7-137.
Note: For Open Access, the Profile Name could be “DVLK-Vacant” since the Access Island number is not used as part of Scoping.
• Have a port profile available that reflects the type of port and the capabilities desired, such as “DVLK-AI01-100Mbps”.
Note: In this profile, the VLAN Configuration is not included.
• Have a customer ID ready that reflects administrative naming conventions for this type of provisioning. An appropriate
ID would be the residence address.
7.10.3.3 Pre-provision the Customer
Using the sample names listed above, the following steps are performed:
1. Bring up the Provision New Triple Play Customer Form using one of these methods:
• From the main AlliedView NMS menu, select Tools -> Customer Management -> Add New Triple Play Customer.
• For an iMAP icon, select Provision -> Port Management. From the Port Management Form select the port for the work
order, which will have no Customer ID, and click Provision New Customer/Port. (An already provisioned port should
always have a Customer ID.)
• From the port table in Network Inventory, right-click the port from the work order and select Provision New
Customer/Port.
2. In the Provision New Triple Play Customer Form, enter a Customer ID, in this example the residence address.
3. Click on Add Customer Info to add the additional text.
4. Select the iMG/RG General Profile, in this case “DVLK-AI01-Vacant”. Because of scoping, only those devices from Access
Island 1 are available.
5. Enter a port Profile. Only those port profiles relevant for the type of port selected are available.
6. Review the filled out form, as shown in Figure 7-138.