User guide

Provisioning the iMG/RG Datafilling the Triple Play Form - Examples
757
AlliedView NMS Administration Guide
FIGURE 7-86 Triple Play Form with x908 Upstream Device
Once the form is filled in and the NMS has performed provisioning in software, the iMG will begin its provisioning either
immediately (if the iMG/RG is already connected and powered on), or later (when the iMG /RG is connected and powered
on). When complete, the iMG is listed and includes its IP address, upstream port, and the associated profiles. Refer to the
following figure.
FIGURE 7-87 iMG/RG Provisioned - Complete
7.6.10 Configuration 9 - Microsoft Mediaroom with the iMG/RG
The Mediaroom configuration is sometimes referred to as a “whole home” configuration. With Mediaroom you can
configure the iMG/RG device to allow all devices that are connected to the iMG to communicate to each other and share
content. In this configuration all Mediaroom devices such as PCs, printers, DVRs, STBs, etc. can share content through the
same local network. (Additional configuration may be required in STB, PC or other Mediaroom devices to setup a fully
connected Mediaroom environment.)
Sharing a local network also allows you to connect any video or data devices to LAN ports configured for Mediaroom with
the iMG. The iMG assigns IP addresses to connected devices using DHCP and allows data sharing through the local network
with connections to upstream services as requested by Mediaroom devices.