User guide

Provisioning the iMG/RG Datafilling the Triple Play Form - Examples
734
AlliedView NMS Administration Guide
FIGURE 7-63 RG Voice Profile - Static Configuration
Moreover, some hard-coded values must be known before beginning the procedure, since these static Profiles will make
certain fields appear that must be filled in on the Triple Play form:
• RGMgmt IP Address - This does not need to be known if the user sets up discovery so that the IP address is included in
the Discovery process. In most cases, however, the user must have a unique IP address and will associate this with the
RGMgmt VLAN. This is highlighted in the next subsection.
• Internet service IP Address
• Voice Service IP Address
• Masks for the IP Addresses
• MAC address for the iMG/RG
7.6.4.2 Setting Up the IP Address for the iMG/RG
To give the iMG/RG a manual IP address, and to associate this address with the RGMgmt VLAN, the user should perform the
following, noting that the procedure is different for Ethernet vs. ADSL types.
1. Choose the method of giving the iMG./RG the unique IP address depending on the type.
• For Ethernet:
1. Connect an iMG/RG ethernet console port to the console port of a PC.
Note: The console cable is sold separately by ATI. Use n-8-1-38400 for the console port setting.
2. Log in to the iMG/RG and set up the unique IP address
• For ADSL
1. Connect the PC ethernet port to a LAN port on an iMG/RG.
2. Power cycle the ADSL modem.
3. While the modem is powering up/reconnecting, hold the reset button of the RG for ~30 seconds.
4. The ADSL modem now has the following:
- IP Interface of ip0